Cycle Time; Enable Object; Object Value Enable Object - ABB i-bus KNX Product Manual

11.6.2.3

Cycle time

Options:
The telegrams of the object during operation are sent cyclic on the bus.
The parameter specifies the time interval from which a new sending of the telegrams occurs.
11.6.2.4

Enable object

Options:
Deactivated:
■
– Object "GFx: enable" is not enabled.
Activated:
■
– Object "GFx: enable" is enabled. The function "Cyclic telegram" can be temporarily
blocked via the object.
The 1-bit communication object "GFx: enable" can be enabled with this parameter.
Note
If the "Enable object" parameter is activated, the following parameters can be
set:
■
■
11.6.2.5

Object value enable object

Options:
Normal:
■
– If an Off telegram is received via the object "GFx: enable", the function "Cyclic telegram"
is blocked. An On telegram deactivates the blockage.
Inverse:
■
– If an On telegram is received via the object "GFx: enable", the function "Cyclic telegram"
is blocked. An Off telegram deactivates the blockage.
The parameter is used to specify whether function "Cyclic telegram" is blocked temporarily at
the receipt of an On or Off telegram.
Note
This parameter can only be set if the "Enable object" parameter is set on
"activated".
Product manual 2CKA001473B9482
Description of application and parameters
Setting option from 00:00:55 to 01:30:00 (hh:mm:ss)
Deactivated
Activated
"Object value enable object"
" Enable object after return of voltage"
Normal
Inverse
Application "General functions"
│143