Control Elements - ABB i-bus KNX Product Manual

9.1

Control elements

1
2
Fig. 20: Control elements
[1] Selection of one of the following functions in the sequence of the list.
Prerequisite: The parameters for the functions have been set beforehand.
Setpoint adjustment
■
Off/On (OFF; long press of the button)
■
Fan speed levels
■
Switchover heating/cooling
■
Keep the button pressed until the display flashes. Press the button several times until
the desired function is displayed.
[2] Reduce temperature, press the button
[3] Increase in temperature reduction; press the button
[4] ECO mode, press the button
[5] Additional functions (dependent on the configuration and parameter setting)
[6] Additional operating buttons (dependent on the configuration and parameter setting)
Note
The display of the room temperature controller always indicates the set-value
temperature. This can be changed via the arrow buttons of the control element.
Product manual 2CKA001473B9482
4 5
6
blind
3 5
Operation
5
relax
6
5
reading
│31