Setpoint Adjustment; Setpoint Adjustment - Maximum Manual Increase During Heating Mode (0 - 9°C); Setpoint Adjustment - Maximum Manual Reduction During Heating Mode (0 - 9°C); Setpoint Adjustment - Maximum Manual Increase During Cooling Mode (0 - 9°C) - ABB i-bus KNX Product Manual

11.5.94 Setpoint adjustment

Note
This parameter is only available if the "Device function" parameter is set on
either "Single device" or "Master device".
11.5.95 Setpoint adjustment — Maximum manual increase during heating mode (0 - 9°C)
Options:
This preset can be used to limit the manual increase during heating.
Note
This parameter is only available when parameter "Controller function" is set on
"Heating" and parameter "Control value type" on "2-point 1 bit, On/Off" or "2-
point 1 byte, 0/100%".
11.5.96 Setpoint adjustment — Maximum manual reduction during heating mode (0 - 9°C)
Options:
This preset can be used to limit the manual decrease during heating.
Note
This parameter is only available when parameter "Controller function" is set on
"Heating" and parameter "Control value type" on "2-point 1 bit, On/Off" or "2-
point 1 byte, 0/100%".
11.5.97 Setpoint adjustment — Maximum manual increase during cooling mode (0 - 9°C)
Options:
This preset can be used to limit the manual increase during cooling.
Note
This parameter is only available when the "Control function" parameter is set on
"Cooling," "Cooling with additional stage," "Heating and cooling" or "Heating and
cooling with additional stages".
Product manual 2CKA001473B9482
Description of application and parameters
Setting option between 0 - 9
Setting option between 0 - 9
Setting option between 0 - 9
Application "Function block RTC"
│111