Panasonic EBL512 Operating Instructions Manual page 117

Panasonic Eco Solutions Nordic AB
MEW01457
""
""
""
"Return"
"Return"
When scrolling the message "Please Wait....." might be shown for "a second" and "No more sensors
found in the system" (before the lowest and after the highest possible technical number in the system).
Scroll to menu U5.
"1"
"A"
"A"
"Return"
Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
Sensor: 00000N
Current algorithm: nnnnnn
Sensor: 00000N
Momentary: XX°C
Sensor: 00000N
Current algorithm: nnnnnn
Start Sensor : 000000
Sensor values
Printout: (1=yes)
Here follows the alternative "1" (printout).
Sensor values
Printout: (1=yes)
Start Sensor : 000000
End Sensor :
Printing started. To stop printing press
C and 0 simultaneously
Start Sensor : 000000
Sensor values
Printout: (1=yes)
Perf. Factor = Performance factor:
Low (min. 0) = The detector is mounted in a "stable" environment.
High (max. 2.55) = The detector is mounted in an "unstable" environment.
See also Planning Instructions, chapter "Performance factor".
Table showing the algorithms and the shortenings respectively:
Min: XX°C
Max: XX°C
ACCEPT?
115
Write the sensor's techn.
number and/or press "A"
to accept or press
"Return" to menu U5.
Scroll or press "Return"
U5
to menu H4. Scroll or
press "Return" to log off.
Press "1" to accept.
U5
Write the techn. numbers
and/or press "A" to
accept.
Press "A" and menu U5
will be shown again.
Write the sensor's techn.
number and/or press "A"
to accept or press
"Return" to menu U5.
Scroll or press "Return"
U5
to menu H4. Scroll or
press "Return" to log off.