Panasonic EBL512 Operating Instructions Manual page 6

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x
21 EBL512 settings download ___________________ 87
21.1 Control Units in a TLON network ____________________ 87
22 Restart ___________________________________ 88
22.1 Boot menu _______________________________________ 90
23 Access ____________________________________ 92
24 Perform monthly test (H1) ___________________ 93
25 Disable or re-enable (H2) ____________________ 96
25.1 Disable zone (H2/B1) ______________________________ 97
25.2 Disable zone / address (H2/B2) _______________________ 98
25.3 Disable control output (H2/B3) _______________________ 99
25.4 Re-enable zone (H2/B4) ___________________________ 101
25.5 Re-enable zone / address (H2/B5) ____________________ 102
25.6 Re-enable control output (H2/B6) ____________________ 103
25.7 Re-enable non-reset zone / address (H2/B7) ____________ 105
25.8 Disable / Re-enable all control, exting. and ventilation outputs
(H2/B8) ______________________________________________ 106
25.9 Disable / Re-enable alarm devices (H2/B9) ____________ 107
26 Set calendar and clock (H3) _________________ 108
26.1 Daylight saving time ______________________________ 109
27 Present system status on display and printer (H4)110
27.1 Disablement (H4/U1) _____________________________ 110
27.2 Disablement by time channel (H4/U2) ________________ 111
27.3 Doors open (H4/U3) ______________________________ 112
27.4 Activated 2-zone/address dependent zone/address (H4/U4) 113
27.5 Sensor values (H4/U5) ____________________________ 114
27.5.1 Reset of a week average sensor value _____________ 116
27.5.2 Algorithm setting via menu H4/U5 _______________ 117
27.6 Sensors activating SERVICE signal (H4/U6) ___________ 122
27.7 Event log (H4/U7) ________________________________ 123
27.8 Configuration (H4/U8) ____________________________ 124
28 Service (H5) ______________________________ 125
28.1 Access code for service (H5) _______________________ 126
28.2 Calibration of supervised outputs (H5/A1) _____________ 127
28.3 Sensitive fault detection mode (H5/A2) _______________ 128
28.4 Direction for communication on COM-/BS4-loop (H5/A3) 129
28.5 Show information about Site Specific Data (H5/A4) _____ 130
28.6 Display current consumption in unit (H5/A5) ___________ 131
28.7 Display current consumption COM-/BS4-loop (H5/A6) __ 132
28.8 Display statistics for COM-loop (H5/A7) ______________ 133
28.9 Select unit on COM-loop to use for trigging (H5/A8) ____ 134
28.10 Activate address setting mode for DU (H5/A9) _______ 135
28.11 Change access code for PC-communication (H5/A10) __ 136
28.12 Change access code for service (H5/A11) ___________ 137
4