Set Calendar And Clock (H3) - Panasonic EBL512 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01457
26
Action
"Access"
Scroll to menu H3.
"A"
"A" or
"Return"
Rev: - Operating Instructions Fire alarm system EBL512, V2.7.x

Set calendar and clock (H3)

The RTC component has a capacitor as a backup power supply.
Normally, date, day of the week and time only have to be set when the
power is turned on the control unit for the first time.
clock might be corrected, so that the "time stamps" for fire alarms,
faults, etc. will be correct.
In this menu is also the S/W (system program) version shown.
The calendar and clock can be set in any c.i.e. for the whole system.
Every day (at midnight) the calendar and clock will be synchronised.
NOTE! The information shown in the display will be saved when
you press "A". If you don't want to change anything (e.g. if you
only want to see the S/W version), press "Return" (instead of "A")
to return to menu H3.
Text in display
Set calendar and clock
Date: YY-MM-DD Time: hh:mm:ss
Weekday:W (1=M, 7=S)
NOTE! The date is in some conventions / languages
shown as DD-MM-YY.
Set calendar and clock
98
The capacitor can supply the RTC for a couple of days. When the power
has been turned off, it is recommended to check / set the date and time in
menu H3.
ACCEPT? H3
VER:vvvvvvvvvvvv
ACCEPT? H3
108
98
If required, the
Comments
According to chapter
"Access", see page 92.
Here is the S/W version
shown (e.g. VER: 2.4).
The time shown, is the
time when "A" was
pressed (in menu H3).
Change the date, time
and/or weekday. The
"clock" starts again from
the date, time, etc. shown
in the display.
NOTE! Press "Return"
instead of "A" if no
changes are to be done.
Scroll or press "Return" to
log off.