Set Calendar And Clock (H3) - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748
25
Action
"Access"
Scroll to menu H3.
"A"
"A" or
"Return"
Rev: 1

Set calendar and clock (H3)

The RTC component has a built-in battery. Normally, date, day of the
week and time don't have to be set, except when the control unit is
powered for the first time but if required, the clock might be corrected,
so that the "time stamps" for fire alarms, faults, etc. will be correct.
In this menu is also the S/W (system program) version shown.
The calendar and clock can be set in any c.i.e. for the whole system.
Every day (at midnight) the calendar and clock will be synchronised.
NOTE! If you don't want to change anything (e.g. if you only want
to see the S/W version), press "Return" (instead of "A") to return to
menu H3.
Text in display
Set calendar and clock
Date: YY-MM-DD
Weekday:W (1=M, 7=S)
NOTE! The date is in the Ukrainian convention (S/W
version > 2.2.3) shown as DD-MM-YY.
Set calendar and clock
Operating Instructions Fire alarm system EBL512 V2.3.x
ACCEPT? H3
Time: hh:mm:ss
VER:vvvvvvvvvvvv
ACCEPT? H3
87
Comments
According to chapter
"Access", see page 72.
Here is the S/W version
shown (e.g. VER: 2.0).
The time shown, is the
time when "A" was
pressed (in menu H3).
Change the date, time
and/or weekday. The
"clock" starts again from
the date, time, etc. shown
in the display.
NOTE! Press "Return"
instead of "A" if no
changes are to be done.
Scroll or press "Return" to
log off.