Change Access Code For Service (H5/A11) - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748
27.12
Action
"Access"
Scroll to menu A11
"A"
Enter the old code, the
new code and the new
code again.
Rev: 1

Change access code for service (H5/A11)

For security reasons, the default code should be changed.
Text in display
Change access code for service
Access code: _
New code:
Access code: ****
New code: ****
Incorrect access code, NO change
Change access code for service
NOTE! After change of access code it is recommended do a "Safe
shutdown of the control unit" (see menu H8/S8). This will save the
SSW data (e.g. the new code) in a Flash ROM (see page 69).
If the valid access code is unknown a "back door code" is available.
Operating Instructions Fire alarm system EBL512 V2.3.x
ACCEPT? A11
Verify:
Verify: ****
ACCEPT? A11
115
Comments
According to chapter
"Access code for service
(H5)", see page 104.
The digits are replaced
(****) in the display.
The code was not correct.
Try again.
The code was correct and
is now changed to the new
code. Scroll or press
"Return" to H5. Scroll or
press "Return" to log off.