Panasonic EBL512 Operating Instructions Manual page 21

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1
Push buttons / Keypad on the Control Panel (CP)
Key/push button
P6 Fault acknowledge
(yellow)
P7 Paper feed (white)
P8 Access (white)
P9 Return (white)
1 – 9 and 0
C
A
← →
↑ ↓
Operating Instructions Fire alarm system EBL512 V2.3.x
Operation/function
Used to acknowledge the faults shown in menu H6. Also used
to acknowledge SERVICE signal, see menu H8/S4.
Used for paper feed (when a built-in printer is available).
Used to log on, i.e. to get access to the menu tree (via an access
code) to carry out disablements, etc. In conjunction with fire
alarm, some information is available and some actions are
possible to perform via the "Fire alarm menu" (X1-X9) without
log on, see chapter "Fire alarm", page 34.
Used to stop input of data, leave a menu ("one step up") and to
log off.
Numeric keys for the figures 0-9.
Used to clear /delete just written data.
Used to accept a menu and accept input of data.
Left / right keys are used to move the cursor in a menu.
Up / down keys are used to scroll between the menus.
16
In Chinese convention only the following is valid: If "P7" and "C" are
pressed simultaneously, the printer will be disabled. This is indicated by the
LED "Printer disabled". The printer will be disabled until re-enabled again,
i.e. "P7" and "C" are pressed simultaneously. All information that should
have been printed while the printer was disabled will be lost (not printed).
19
16