Normal Operation; Alphanumeric Display In The Control Unit - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1
6
6.1
Operating Instructions Fire alarm system EBL512 V2.3.x

Normal operation

When the control unit / system is in normal operation, i.e. no fire
alarms and normally no faults, no disablements, no service signal, no
zones in test mode, no activated interlocking in / outputs and/or no
open doors, only the LED "Operation" (L6) is to be lit.

Alphanumeric display in the control unit

In normal operation, there shall be no information shown in the
alphanumeric display in the control unit but some information can be
shown. The type of information and the priority order is as follows:
17
1. Fire alarms
2. Co-incidence alarms
3. Pre-warnings
4. Evacuate information, only valid in "British Standard" and
"Ukrainian" conventions (S/W version > 2.2.3).
5. Faults (not acknowledged)
6. Disablements
7. Zones in Test mode
8. Interlocking inputs / outputs active (not valid in Chinese
convention)
NOTE!
The different type of alarms, faults, etc. are described in other parts of
this document.
17
Fire alarm have a "log off function", i.e. if a menu window is open when a
fire alarm is activated, an automatic menu log off will take place and the fire
alarm will be presented in the alphanumeric display instead.
Some information is available and some actions are possible to perform via
the "Fire alarm menu", see chapter "Fire alarm", page 34.
20