Access Level 4; Access Level 5 - Panasonic EBL512 Operating Instructions Manual

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1
7.5
7.6
Operating Instructions Fire alarm system EBL512 V2.3.x

Access level 4

22
From access level 2
gives access to the following menus, normally used by Service /
Commissioning Engineers:
Same menus as in access level 2 and 3 plus the following:
H5 Service
A1 Calibration of supervised outputs
A2 Sensitive fault detection mode
A3 Direction for communication on COM-/BS4-loop
A4 Show information about site specific data.
A5 Display current consumption in control unit
A6 Display current consumption on COM-/BS4-loop
A7 Display statistics for COM-loop
A8 Select unit on COM-loop (and BS4 loop) to use for trigging
A9 Activate address setting mode for DU
A10 Change access code for PC-communication (access level 5).
A11 Change access code for service (access level 4).

Access level 5

Used by Service / Commissioning Engineers when a PC is to be
connected to the control unit, i.e. when Win512 is to be used for
backup, download of Site Specific Data, S/W, settings, configurations,
C.U. and system data, on-line status checking, etc.
22
If code for access level 4 has been used to login to access level 2, new
login to access level 4 is not required.
24
, the user can logon to access level 4, which