Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
28.1
Action
"Menu"
Scroll to menu H5 or
H8
"↵ "
Enter code for level
3A (4 digits)
H5
Code for level 3A
(4 digits)
alt.
H8
Code for level 3A
(4 digits)
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Access code for service / maintenance (H5
and H8)
Access code to level 3A is required.
If login to level 2B was made with code for level 3A, no code is
required here.
Text in display
H5 Service
H8 Maintenance
Access code: a
Access code: ****
NO ACCESS!
A1 Calibration of supervised outputs
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in control unit
A5 Display current consumption on COM-loop
A6 Display statistics for communication
A7 Activate address setting mode for DU
S1 Disconnect loop / zone line input
S2 Re-connect loop / zone line input
S3 Acknowledge SERVICE signal
S4 Clear weekly average
S5 Test of alarm devices
S6 Safe shut down of control unit
S7 Activate address in alarm mode
S8 Synchronize the control units
S9 Change code for service / maintenance
S10 Change code for PC-communication
116
Comments
According to chapter
"Access", page 85
If login was made with
code for level 3A, no
code is needed.
The digits are replaced
with **** in the display
This info. is shown if
you enter a not correct
access code. Try again.
The access code was
correct.
Press "↵ " or scroll to the
wanted menu and press
"↵ ".
The access code was
correct.
Press "↵ " or scroll to the
wanted menu and press
"↵ ".
Advertisement
Table of Contents
