Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
31.10
Action
"Menu"
"↵ "
Scroll to menu S9.
"↲ "
Enter the old code, the
new code and the new
code again.
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Change code for service / maintenance
(H8/S9)
For security reasons, the default code should be changed.
Text in display
S1 Disconnect loop / zone line input
S2 Re-connect loop / zone line input
S3 Acknowledge SERVICE signal
S4 Clear weekly average
S5 Test of alarm devices
S6 Safe shut down of control unit
S7 Activate address in alarm mode
S8 Synchronize the control units
S9 Change code for service / maintenance
S10 Change code for PC-communication
S9 Change code for service / maintenance
Access code:
New code:
Access code: ****
New code: ****
Incorrect access code, NO change
S9 Change code for service / maintenance
NOTE! After change of access code it is recommended do "Safe
shutdown of the control unit" (see menu H8/S6). This will save the
SSW data (e.g. the new code) in a Flash ROM (see page 137).
If the valid access code is unknown a "back door code" is available.
Verify:
Verify:
****
143
Comments
Procedure according to
chapter "Access code for
service / maintenance (H5
and H8)", see page 116.
The digits are replaced by
**** in the display.
The access code was not
correct. Try again.
The access code was
correct and is now changed
to the new code.
Scroll to another menu or
press "ESC".
Advertisement
Table of Contents
