Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
L1
L2
L3
L4
L5
L6
L7, L8
L9, L10
L11, L12
L13, L14
Figure 2. The EBL512 G3 front with display; The Fire Brigade
Panel (FBP) is the upper part and the Control Panel (CP) is the
lower part.
The look might vary according depending on
language, country, etc. (A front with texts in English is shown in
the figure).
See also chapter "LED indicators and push
buttons", page 17.
The fire brigade personnel use the FBP to see which alarm point /
zone(s) having activated fire alarm and to take required operational
control of the system. In the graphical display, the information in the
upper part is depending on how many alarm points / zones having
generated fire alarm. In the middle part a user definable text message
(alarm text) is shown for each alarm point / zone in alarm - if
programmed.
The CP is to "communicate" with the system, i.e. for commissioning,
monthly tests, maintenance, etc. Access codes for different access
levels are required. A keypad is used to get access to the system (a
menu tree with main and sub menus) and for different manoeuvres.
The CP has several LEDs for system status.
In the Australian front only, below the "P3" button, there is also a
"Disable" push button, with which you can "Disable zones in alarm".
16
P1
P2
P3
P4 – P7
P8
Advertisement
Table of Contents
