Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
Rev: -
18
18.1
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Commissioning an installation
Before you connect the power supply to a control unit, all other cable
connections shall be made. Check once more that they are correct.
Single Control Unit
1. Take away the rectifier fuse (F1) and the battery fuse (F2) on the
main board 5010. NOTE! In a single / standalone control unit
there shall be no TLON connection board (1590) plugged on the
main board.
2. Connect the batteries to the main board 5010, terminal block "J2".
NOTE! There shall be an in line fuses (F) on the cable between
the batteries, see drawing 512 G3 – 21.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED
BY INCORRECT TYPE.
ACCORDING TO THE INSTRUCTIONS.
3. Connect the rectifier to the mains (230 V AC).
NOTE! It shall be connected to a household removable fuse for
the fire alarm c.i.e. only, via a two-way circuit breaker.
The mains cable shall be securely clamped and the wires shall be
as short as possible. The mains safety earth (ground) shall,
however, be longer than the other wires, to ensure that it is the
last to be disconnected if the mains cable clamp should fail.
The lid protecting the screw terminals shall after the installation
be correctly applied.
4. First replace the battery fuse (F2) and then the rectifier fuse (F1)
on the main board 5010.
5. LED "Operation" (L5) indicate that the 24 V DC power supply is
okay (rectifier and/or battery).
6. The c.i.e. will now restart (see chapter "Restart", page 81).
7. The site specific data (SSD) – created in WinG3 - can now be
downloaded, see chapter "Programming (SSD download)", page
75.
8. See also chapter "Calibration of supervised outputs (H5/A1)",
page 117.
33
Cable tie shall be mounted to keep the mains wires well separated from the
24 V DC wires.
34
Follow National regulations.
71
DISPOSE USED BATTERIES
33
34
Advertisement
Table of Contents
