Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
27.4
Action
"Menu"
Scroll to menu H4.
"↵ "
Scroll to menu U4.
"↵ "
"↵ "
"↵ "
"ESC"
Rev: -
Sensor values (H4/U4)
The very first week average sensor value is calculated within 2
minutes after SSD download & restart. During these 2 minutes can no
fire alarm be activated and the sensor value "000" will be shown.
The "Performance factor" and "Min. / Max." values are updated each
night (00:00), i.e. the values shown are from the previous day.
Text in display
H4 Present system status
U1 Disablement
U2 Disablement by time channel
U3 Open doors
U4 Sensor values
U5 Sensors activating SERVICE signal
U6 Event log
U7 Information
U4 Sensor values
Start sensor: 000000
↵
(When "
" is pressed, the sensor values will be shown in the
display. An examples which shows the values from an analog
multi detector 4300 and an analog heat detector 3308:)
Sensor: 001-01 (technical address 000001)
Momentary: XX.X%/m
Perf factor: X.XX%/m
Algorithm: X-XX
Momentary: XX°C
Algorithm: XX
Sensor: 001-03 (technical address 000002)
Momentary: XX°C
Algorithm: XX
Escape
menu
Print
Start sensor: 000000
U4 Sensor values
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Weekly: XX.X%/m
Min: XX.X%/m
Max: XX.X%/m
Min: XX°C
Max: XX°C
Min: XX°C
Max: XX°C
108
Comments
According to chapter
"Access", see page 85.
Write the technical number
↵
and/or press "
" to start
as from sensor 000001.
A list in which you can
scroll with "▼" or "▲".
If printer is mounted the
soft key "Print" will be
visible, else not. Press
"Print" for a print-out.
If there are no sensors
(analog detectors) when
↵
"
" is pressed, the list
view will not open.
Write another technical
↵
number and press "
" or
press "ESC".
Scroll to another menu or
press "ESC".
Advertisement
Table of Contents
