Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
Rev: -
19.3
19.4
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
FAULT: Site specific data (SSD), CU nn
YYYY-MM-DD HH:MM
This text message means that the SSD have not been downloaded
properly, i.e. a new download has to be performed.
Control Units in a TLON network
The SSD for all control units can be downloaded via a PC (WinG3),
connected to one control unit. The download will be performed to the
control units, one at a time, according to the chapter "Single Control
Unit" above. The download is performed in a consecutive order, i.e.
0-1-2-3-4-......-29 amongst the selected control units but the control
unit where the PC is connected will automatically be the last one to
get the SSD downloaded.
When the SSD download to a control unit is completed, that control
unit will automatically restart, see chapter "Restart", page 81.
User definable text messages download
When a fire alarm is activated (e.g. an addressable alarm point), the
presentation number (Zone - Address) will be shown in the control
unit display as well as in the ext. FBP 1826 / 1828 display
will also be shown a user definable alarm text, if programmed. See
page 40.
Each alarm point can have a unique text message.
Each zone can have a unique text message.
Each zone line input can have a unique text message.
The user definable text messages will be printed out when a printer is
available.
See also chapter "Fire alarm", page 39.
All user definable text messages, up to 40 alphanumeric characters
each, are created and downloaded via WinG3.
Instructions, chapter "User definable text messages".
38
This is also valid for the Ext. Presentation unit 1728 and the Alert
Annunciation units 1735 / 1736.
76
38
. There
See Planning
Advertisement
Table of Contents
