1 Unpacking and handling
Read carefully through the safety instructions, before the track motion is unpacked and
installed.
1.1 Lift
1.1.1 Lifting instructions
Stand modules can be moved using a fork lift truck or an overhead crane.
Only units that are 6 meters or shorter may be lifted. If the units are joined, the joints must be
prefitted on delivery.
1.1.2 Lifting the track motion
Proceed as follows to lift the track motion:
1. Move the carriage as close to the center of the track motion as possible.
2. Position the forks along the rail module
3.
Lifting zones
The illustration shows the zone on the track motion where the forks/lifting straps can
be placed.
Figure 1 The lifting zones for a fork lift truck (X) and an overhead crane (Y)
3HEA 800 970-001 Rev. D, Mars 2006
Lifting using a fork lift truck
in the lifting zone in accordance with
position (X) in the figure below.
Unpacking and handling
Lifting using an overhead crane
Dismantle the side covers from the track
motion if these are prefitted.
Wrap two lifting straps around each side of
the carriage in accordance with position (Y)
in the figure below.
Lift
2-1