Table of Contents
Advertisement
When testing indicates a blockage has occurred in any divider valve, that divider
Step 5
valve must be disassembled and cleaned.
Dirt and foreign material are the worst enemies of any lubricating equipment. All servicing and
disassembling should be carried out under the cleanest possible conditions.
Before disassembling any divider valve.
1. Make a sketch and note as to the arrangement
2. Also remove end plugs only and try to move
DO NOT insert hard metal objects into piston bore (i.e., punches, screw drivers, etc.) use a
brass rod and hand pressure only!
3HEA 800 970-001 Rev. D, Mars 2006
Action
of the intermediate sections.
For example: INLET 10T-20S-10T-30S END.
each piston back and forth without removing the
piston from the intermediate section.
Maintenance instructions
Locating blockage in Series-Flo systems
Info/Illustration
3-15
Advertisement
Chapters
Table of Contents
