Panasonic LP-GS Series Serial Communication Command Manual page 110

⿎ Setting request data : When deleting point setting
Start
PRD
code
⿎ Data description
Name
(> Name in LP-400/V)
Object No.
(> Point radiation No.)
Point No.
(First point No. to delete)
Last point No. to delete
Total data length
⿎ Data example
Condition: Object No. = 1, Point No. = 5, Last point No. to delete = 10
• Setting
Transmission data
110
[Object No.] [Point No.]
S [Last point No. to delete]
8-byte
Data length
Data content
[byte]
"00"–"15": Object No. 1400
2
to 1415
3 "000"–"049"
3 "000"–"049"
8 The data length is fixed.
[STX] PRD
ME-LP-GS-SR-COMP-3
(Check
End code
sum)
• Specify the point no. to delete.
• To delete two or more points, this number is
the start point number to delete.
• Specify the smaller no. to the first point no.
than the last point no.
• Deletes all points from the specified first
point no. to the last point no.
• To delete the only one point, specify the
same no. to the first and last point no.
• This command is accepted even if there is
no setting in the specified point no.
S 01005010 [CR]
Remarks