Panasonic LP-GS Series Serial Communication Command Manual page 38

Command Content to be specified
LTS Lot character
RKS Registered character
strings
FNN File name
FNM File name
CDF Graphic file name
• For details of the character codes, refer to "Character Code Table" (P.163).
• The one-byte and two-byte represent the data input method, and there is no distinction between the one-byte and two-
byte for marking characters.
• For the input character to Bar code/2D code object, depending on the code type, the acceptable character type is
restricted to either one-byte or two-byte character. In this case, the input character is converted automatically to the
acceptable type.
• If the data contains any characters which belong to the non-supported character code, it cannot be set or read out.
• Characters in TrueType object cannot be set with communication command.
• With LP-400/V compatible command mode, you cannot set the characters of the character objects other than the
reference list type.
Example of character input
• To input "ABCD"
Input using the ASCII codes*: 41 42 43 44
Input using the Shift JIS codes*: 8260 8261 8262 8263
* Spaces in the example above are not included in the input data.
38
Restrictions on the input characters
• The ASCII code and Shift JIS code can be mixed.
• Control codes cannot be used.
• Functional characters cannot be used.
• No line feed is allowed.
ME-LP-GS-SR-COMP-3