Panasonic LP-GS Series Serial Communication Command Manual page 54

Type Name
Laser power
Scan speed
Laser frequency / pulse cycle
Laser fine tune
Line width / filling line spacing
Laser radiation for measurement
System clock
Command mode
*1 : Only LP-GS051(-L) type, LP-RC350S, LP-RF series, LP-RV series
*2 : Only LP-RC series, LP-RF series, LP-RV series
• The following commands used in LP-400/LP-V series cannot be available with this product.
• BBS: Bar code/2D code characters
• CDD: DXF logo conditions
• FIG: Processing element
• LAY: Processing condition
• CWL: CW Pulse cycle/duty
• MWT: Flying object wait
• PWR: Power check
• ECR: Error code
• ERA: Era year
• WKM: Week setting
• ENV: I/O environment
54
Code Functions
LPW Sets the laser power for the current file.
SSP Sets the scan speed for the current file.
MPL Sets the laser frequency (LP-GS/LP-RC) or pulse
cycle (LP-RF/LP-RV) for the current file.
WTC Fine-tunes lasing quality such as starting and ending
point by each file.
WDC Sets the line width necessary to avoid crossing at
marking intersection and the filling line spacing for
bold characters and bar codes.
SPT Controls "laser radiation for measurement" used to
measure laser output by a commercially available
power meter.
YMD Sets the date and time of the system clock of the laser
marker.
RSM Switches the command mode between LP-400/
LP-V compatible mode and the standard one. This
command is available when LP-400/V compatibility
setting is enabled in system settings.
ME-LP-GS-SR-COMP-3
Refer
(P.127)
(P.128)
(P.129)
(P.130)
(P.132)
(P.133)
(P.134)
(P.135)