Step & Repeat Fine-Adjustment: Sra - Panasonic LP-GS Series Serial Communication Command Manual

3-10-5 Step & repeat fine-adjustment: SRA
Sets the fine-adjustment of "Step & repeat" to mark the same marking contents on multiple locations in one file.
Setting request data / response data for readout vary by the setting subject to fine-adjustment.
• Settings by this command are applied to the object group No. 1000. To the object group No. 1000 the marking data
converted from LP-400/V files and the data set by LP-400/V compatible command mode belong.
• With LP-400/V compatible command mode, only 100 settings of Step & repeat fine adjustment are available.
• With LP-400/V compatible command mode, Z-movement cannot be set and readout.
• With LP-400/V compatible command mode, "rectangle range" of the adjustment object cannot be set and readout.
⿎ Readout request data
Start
SRA
code
⿎ Setting request data / response data for readout: position/power adjustment for single step
Start
SRA
code
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Data description
Name
Adjustment No.
Adjustment object
Target row
Target column
X-movement
Y-movement
Rotation movement *
Laser power
correction *
Total data length
* These items can be omitted when the both values are 0. It is not possible to omit one side of them.
118
[Adjustment No.]
R
2-byte
[Adjustment No.] [Adjustment object]
[Target row] [Target column] [Adjustment item]
Sub
[X-movement] [Y-movement]
command
( [Rotation movement] [Laser power correction] )
Data length
Data contents
[byte]
2 "00"–"99"
1 "1": Single step
3
"001"–"400"
3
8
"-999.999"–"+999.999" [mm]
8
(7) "-180.00"–"+180.00" [°]
(3) "-50"–"+50" [+/-%]
Fixed length.
35 • When Rotation movement and Laser power correction are not omitted: 35-byte
(25) • When Rotation movement and Laser power correction are omitted: 25-byte
• Response data for readout: 35-byte
(Check
End code
sum)
35-byte or 25-byte
Enables the adjustment item for the
selected row/column.
ME-LP-GS-SR-COMP-3
(Check
sum)
Remarks
• Moves the coordinate of the marking
data in the range of rows/columns
specified.
• It is the movement for the coordinate
after executing Step & repeat.
• When the rotation movement is omitted,
"+000.00" is set.
• Corrects the laser power of the marking
data in the range of rows/columns
specified. Specify the correction ratio
in the range of 100±50% relative to the
laser power for the object to which Step
& repeat applies.
• When this item is omitted, "+00" is set.
End code