Control Sample - Panasonic LP-GS Series Serial Communication Command Manual

2-6 Control Sample

⿎ To switch the file and start marking
1. Laser pumping (ON)
2. File selection by number
3. Shutter open
4. Status checking
5. Marking trigger
No: Mark the
same file
7. Shutter close
8. Laser pumping (OFF)
*1 : From sending the laser pumping on request to completion of laser pumping, the following time will be required.
• LP-GS series: about 8 to 15 seconds
• LP-RC series: about 10 seconds
• LP-RF series: about 7 seconds
• LP-RV series: about 1 second
*2 : Commands from No. 2 to No. 4 above chart can be sent right after turning on laser pumping (without waiting for the
laser pumping completion).
*3 : There is a delay time of around 200ms to max. 1 second from sending shutter open/close command for the actual
shutter open/close operation time.
Besides, with LP-RC series for the first operation of opening shutter after the laser pumping on, it takes around 300ms
to max. 4 seconds.
Remote mode ON
Marking trigger ready: ON
Yes
Change the file to be
marked
No: Finish
operation
6. File selection by number
Remote mode OFF
ME-LP-GS-SR-COMP-3
*1, *2
LSR command
FNO command
*3
SHT command
STS command
No.
MRK command
Yes
SHT command
LSR command
FNO command
45