Communication Check - Panasonic LP-GS Series Serial Communication Command Manual

2-5 Communication Check

Verify if the communications between the laser marker and external control device have been established properly in the
following procedure:
1. Turn ON the power of the external control device
2. Turn ON the key switch of laser marker.
3. Coordinate the communication settings between laser marker and external control device
Refer to "1-1-3 Settings before external control" (P.14).
If the communication settings are changed, restart the laser marker.
4. Set the laser marker to the remote mode
Refer to "1-1-4 Remote mode settings" (P.17).
5. Change the file number of the laser marker (transmit the FNO command)
Start code Command
STX "FNO"
02 46 4E 4F
The transmission data above is just a sample. Start code, check sum ON/OFF, and end code content vary depending on
the communication system settings.
*1 : For the command above, calculate the check sum value as follows:
Convert the data from the start code to those before the check sum into the hexadecimal values according to the
ASCII code table and add them all together. Check sum is the value calculated by converting the lower two digits of
the total value into two characters in the ASCII code.
• 02 (HEX) + 46 (HEX) + 4E (HEX) + 4F (HEX) + 53 (HEX) + 32 (HEX) + 30 (HEX) + 34 (HEX) + 37 (HEX) = 205 (HEX)
• 30 35 (HEX) is the value converted the lower two digits character (lower one-byte) 05 (HEX) into two characters in
the ASCII code
6. Check the response from the laser marker
When the connection and communication settings are appropriate, the laser marker returns response data.
Example of positive response
Start code
ACK
06
Example of negative response
Start code
NAK
15
• To use Ethernet, the end code is [CR] fixed. To use RS-232C, select either [CR] or [CR][LF].
• Check sum cannot be added with Ethernet communication.
44
Sub command
"S"
53
"00" Check sum
30 30 36 36
"06" Check sum
30 36 37 42
ME-LP-GS-SR-COMP-3
Data:
File No. Check sum*1
"2047"
32 30 34 37 30 35
End code
0D (HEX)
End code
0D (HEX)
End code
CR
0D (HEX)