Panasonic LP-GS Series Serial Communication Command Manual page 92

Name
(> Name in LP-400/V)
Narrow element
width
X-position
Y-position
Rotation angle
Quiet/narrow ratio
Wide/narrow ratio
Laser power
correction
Scan speed
correction
Pulse cycle
correction *
Total data length
* Only for LP-RF series and LP-RV series.
• With LP-400/V compatible command mode, "Code marking direction" cannot be set. To this item the setting by Laser
Marker NAVI smart or the initial value if it was not set, is applied.
• With LP-400/V compatible command mode, the automatic setting of the human readable text to CODE39, ITF, and
NW-7 codes is not available. Even enabling the human readable text by Laser Marker NAVI smart, it is disabled when
this command is used.
92
Data length
[byte]
5 "0.050"–"1.000" [mm]
8
"-999.999"–"+999.999" [mm]
8
7 "-180.00"–"+180.00" [°]
4 "00.0"–"20.0"
3 "1.8"–"3.4"
3 "000"–"999" [%]
3 "001"–"999" [%]
(3) "001"–"999" [%]
54 The data length is fixed.
or • LP-GS/LP-RC series: 54-byte
57 • LP-RF/LP-RV series: 57-byte
ME-LP-GS-SR-COMP-3
Data contents Remarks
Specify a larger value than the
line width in the object group
settings.
It is the center coordinate of the
code.
The rotation center is the center
of the code symbol.
Ratio of the quiet zone width to
narrow element width.
Ratio of the wide element width to
narrow element width.
The correction ratio is calculated
using the value set at the laser
settings as 100%.