Character Object Settings (Shortened): Spc - Panasonic LP-GS Series Serial Communication Command Manual

3-5-5 Character object settings (shortened): SPC

Sets only X-/Y-position and laser power correction in the character object settings.
• You can use this command as a shortened command consisting only of X-/Y-positions and laser power correction of the
character object settings (STC) command.
• This command is applied to the character objects (reference list type).
⿎ Setting request data / response data for readout
Start
SPC
code
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Readout request data
Start
SPC
code
⿎ Data description
Name
(> Name in LP-400/V)
Object No.
(> Character condition No.)
X-position
Y-position
Laser power correction
Total data length
⿎ Example of command settings
Condition: Object No. = 01, X-position = 15, Y-position = -10, Laser power correction = 80
• Setting
Transmission data
• Readout
Transmission data
Response data
78
[Object No.] [X-position] [Y-position]
Sub
[Laser power correction]
command
[Object No.]
R
2-byte
Data length
[byte]
"01"–"60": Object No. 1001 to
2
1060
8
"-999.999"–"+999.999" [mm]
8
3 "000"–"999" [%]
21 Fixed length.
[STX] SPC
[STX] SPC
[STX] SPC
21-byte
(Check
End code
sum)
Data contents
S 01+015.000-010.000080
R 01 [CR]
A 01+015.000-010.000080
ME-LP-GS-SR-COMP-3
(Check
End code
sum)
Remarks
Specifies the origin coordinate of
character strings.
The correction ratio is calculated using
the value set at the laser settings as
100%.
[CR]
[CR]