Panasonic LP-GS Series Serial Communication Command Manual page 120

⿎ Setting request data / response data for readout: position/power adjustment for row or column
Start
SRA
code command
Sub command is "S" for the setting request data and "A" for the response data for readout.
⿎ Data description
Data length
Name
Adjustment No.
Adjustment object
Target row
or
Target column
X-movement
Y-movement
Rotation
movement *
Laser power
correction *
Total data length
* These items can be omitted when the both values are 0. It is not possible to omit one side of them.
⿎ Example of command settings
Condition: Adjustment No. = 0, Adjustment object = 4, Target row = 2, X-movement = 0.1, Y-movement = -0.2,
Rotation movement = 0, Laser power correction = 0
• Setting
Transmission data
• Readout
Transmission data
Response data
120
[Adjustment No.] [Adjustment object] [Target row/column]
Sub
( [Rotation movement] [Laser power correction] )
Data contents
[byte]
2 "00"–"99"
"3": All columns
"4": All rows
1
"5": Column
"6": Row
3 "001"–"400"
8
"-999.999"–"+999.999" [mm]
8
(7) "-180.00"–"+180.00" [°]
(3) "-50"–"+50" [+/-%]
Fixed length.
32 • When Rotation movement and Laser power correction are not omitted: 32-byte
(22) • When Rotation movement and Laser power correction are omitted: 22-byte
• Response data for readout: 32-byte
[STX] SRA
[STX] SRA
[STX] SRA
[X-movement] [Y-movement]
32-byte or 22-byte
004002+000.100-000.200
S or
004002+000.100-000.200+000.00+00
R 00 [CR]
A 004002+000.100-000.200+000.00+00
ME-LP-GS-SR-COMP-3
(Check
sum)
Remarks
• Enables the adjustment item for the
data at the row/column specified.
• When "all columns" or "all rows" is
set to the adjustment object, the fine-
adjustment is applied to the all settings
from the specified column/row.
• Moves the coordinate of the marking
data in the range of rows/columns
specified.
• It is the movement for the coordinate
after executing Step & repeat.
• When the rotation movement is omitted,
"+000.00" is set.
• Corrects the laser power of the marking
data in the range of rows/columns
specified. Specify the correction ratio
in the range of 100±50% relative to the
laser power for the object to which Step
& repeat applies.
• When this item is omitted, "+00" is set.
End
code
[CR]
[CR]