Panasonic LP-GS Series Serial Communication Command Manual page 77

Name Data length
(> Name in LP-400/V)
Character spacing
angle
Font No.
Bold line width
Laser power
correction
Scan speed
correction
Pulse cycle
correction *
Total data length
* Only for LP-RF series and LP-RV series.
⿎ Example of command settings
Condition: When the character arrangement is straight line
Object No. = 01, System reserved value = 0, First string No. to apply = 01, Last string No. to apply = 03,
Character spacing type = 0, Horizontal and vertical alignment = 0,
Character height = 4.5, Character width = 4, X-position = -10, Y-position = 2.5,
Character spacing = 4.2, Linefeed spacing = 5, Rotation angle = -180,
Font No. = 2, Bold line width = 0.3, Laser power correction = 120,
Scan speed correction = 80, Pulse cycle correction = 100
• Setting
Transmission data
• Readout
Transmission data
Response data
Data contents
[byte]
7 "-180.00"–"+180.00" [°]
1 "1"–"9"
5 "0.000"–"6.000" [mm]
3 "000"–"999" [%]
3 "001"–"999" [%]
(3) "001"–"999" [%]
80 The data length is fixed.
or • LP-GS/LP-RC series: 80-byte
83 • LP-RF/LP-RV series: 83-byte
[STX] STC
[STX] STC
[STX] STC
ME-LP-GS-SR-COMP-3
With LP-400/V compatible command
mode, the character spacing type of
the arc is always set to "fixed spacing".
With LP-400/V compatible command
mode, the fonts from No. 10 cannot be
set and readout.
• If you do not make characters bold,
set 0.000.
• If you make characters bold, set the
bold line width to 1/2 or less of the
character height or width, whichever
is smaller.
The correction ratio is calculated using
the value set at the laser settings as
100%.
010010300004.500004.000-010.000+002.500
S
004.200005.000-180.0020.300120080100
R 01 [CR]
010010300004.500004.000-010.000+002.500
A
004.200005.000-180.0020.300120080100
Remarks
[CR]
[CR]
77