Panasonic LP-GS Series Serial Communication Command Manual page 46

⿎ Create marking data and start marking
Remote mode ON
1. Laser pumping (ON)
2. File selection by number
3. Character object settings
4. Character entry
5. File settings
6. Laser settings
7. Shutter open
8. Status checking
Marking trigger ready: ON
9. Marking trigger
Change settings
No: Finish
operation
13. Shutter close
14. Laser pumping (OFF)
15. Overwrite file
Remote mode OFF
*1 : From sending the laser pumping on request to completion of laser pumping, the following time will be required.
• LP-GS series: about 8 to 15 seconds
• LP-RC series: about 10 seconds
• LP-RF series: about 7 seconds
• LP-RV series: about 1 second
*2 : Commands from No. 2 to No. 8 above chart can be sent right after turning on laser pumping (without waiting for the
laser pumping completion).
*3 : There is a delay time of around 200ms to max. 1 second from sending shutter open/close command for the actual
shutter open/close operation time.
Besides, with LP-RC series for the first operation of opening shutter after the laser pumping on, it takes around 300ms
to max. 4 seconds.
46
LSR command
FNO command
STC command
MCS or STR command
ALC command
LPW, SSP command
SHT command
STS command
No.
Yes
MRK command
Yes
SHT command
LSR command
FOR command
ME-LP-GS-SR-COMP-3
*1, *2
*3
10. Command reception permission ON MKM command
11. Change settings
12. Command reception permission OFF MKM command
After changing the settings set marking trigger ready ON by
"12 Command reception permission OFF".
Various commands