Panasonic LP-GS Series Serial Communication Command Manual page 111

⿎ Readout request data
Start
PRD
code
⿎ Response data for readout
Start
PRD
code
⿎ Data description
Name Data length
(> Name in LP-400/V)
Object No.
(> Point radiation No.)
Point No.
Radiation time
Laser power
correction
X-position
Y-position
Total data length
⿎ Data example
Condition: Object No. = 1, Point No. = 5, Radiation time = 2000,
Laser power correction = 100, X-position = 25.5, Y-position = -7
• Readout
Transmission data
Response data
• If the unit of the radiation time is set to other than [ms], you cannot readout these settings by LP-400/V compatible
command mode.
[Object No.] [Point No.]
R
5-byte
[Object No.] [Point No.] [Radiation time]
A [Laser power correction] [X-position] [Y-position]
31-byte or 5-byte
Data content
[byte]
2 "00"–"15": Object No. 1400 to 1415
3 "000"–"049"
7 "00000.1"–"99999.9" [ms]
3 "000"–"999" [%]
8
"-999.999"–"+999.999" [mm]
8
31 The response data length is fixed.
or • When the specified point no. has settings : 31-byte
5 • When the specified point no. has no settings : 5-byte
[STX] PRD
[STX] PRD
ME-LP-GS-SR-COMP-3
(Check
End code
sum)
Reads out the point radiation setting by a
point.
It is not possible to readout settings for the
multiple points at once.
• If there is no setting in the specified
point no., these items are not included
in the response data for readout.
• The correction ratio of laser power is
calculated using the value set at the
laser settings as 100%.
R 01005 [CR]
A 0100502000.0100+025.500-007.000
(Check
End code
sum)
Remarks
[CR]
111