Panasonic LP-GS Series Serial Communication Command Manual page 93

2. When the code type is CODE128 and EAN/UPC/JAN
Name Data length
(> Name in LP-400/V)
Object No.
(> Bar code No.)
System reserved value
(Area No.)
Code type
Invert
System reserved value
Bar code height
Narrow element width
X-position
Y-position
Rotation angle
Quiet/narrow ratio
System reserved value
(> Double width/narrow
element)
System reserved value
(> Triple width/narrow
element)
System reserved value
(> Quadruple width/
narrow element)
Laser power correction
Scan speed correction
Pulse cycle correction *
Total data length
* Only for LP-RF series and LP-RV series.
• With LP-400/V compatible command mode, "Code marking direction" cannot be set. To this item the setting by Laser
Marker NAVI smart or the initial value if it was not set, is applied.
[byte]
1 "0"–"7": Object No. 1100 to 1107
1 "0"–"9", "A"–"F"
"02": CODE128 without human readable text
"04": EAN/UPC/JAN without human readable text
2
"08": EAN/UPC/JAN with human readable text
"09": CODE128 with human readable text
"0": Do not invert
1
"1": Invert
1 "1" or "0"
Model
LP-GS051(-L)
LP-GS052
7
LP-RC350S
LP-RF200P
LP-RV200P
5 "0.050"–"1.000" [mm]
8
"-999.999"–"+999.999" [mm]
8
7 "-180.00"–"+180.00" [°]
4 "00.0"–"20.0"
3 "1.4"–"2.6"
3 "2.1"–"3.9"
3 "2.8"–"5.2"
3 "000"–"999" [%]
3 "001"–"999" [%]
(3) "001"–"999" [%]
60 The data length is fixed.
or • LP-GS/LP-RC series: 60-byte
63 • LP-RF/LP-RV series: 63-byte
ME-LP-GS-SR-COMP-3
Data contents
Setting range [mm]
"000.050"–"055.000"
"000.050"–"030.000"
"000.050"–"085.000"
"000.050"–"090.000"
Remarks
This value does not affect the
settings anymore.
Set "0" to mark a bar, "1" to
mark a space.
This value does not affect the
settings anymore.
The response data for readout
is always "1".
Specify a larger value than
the line width in the object
group settings.
It is the center coordinate of
the code.
The rotation center is the
center of the code symbol.
Ratio of the quiet zone width
to narrow element width.
• These values do not affect
the settings anymore.
• The readout values are
always "2.0", "3.0" and "4.0"
respectively regardless the
settings.
The correction ratio is
calculated using the value set
at the laser settings as 100%.
93