Panasonic LP-GS Series Serial Communication Command Manual page 95

4. When the code type is data matrix/GS1 data matrix
Name Data length
(> Name in LP-400/V)
Object No.
(> Bar code No.)
System reserved
value
(Area No.)
Code type
Mode
Symbol size (vertical)
Symbol size
(horizontal)
X-position
Y-position
Rotation angle
Module height
(vertical)
Module width
(horizontal)
Total data length
*1 : Available combinations for the number of horizontal and vertical symbol modules (vertical X horizontal)
Auto 00×00
Square: 10×10, 12×12, 14×14, 16×16, 18×18, 20×20, 22×22, 24×24, 26×26,
32×32, 36×36, 40×40, 48×48, 52×52, 64×64, 72×72, 80×80, 88×88
Rectangle 08×18, 08×32, 12×26, 12×36, 16×36, 16×48
• With LP-400/V compatible command mode, "Code marking direction" and "Module marking order" cannot be set. To
these items the settings by Laser Marker NAVI smart or the initial values if it was not set, are applied.
• With LP-400/V compatible command mode, the automatic setting of the human readable text to Data matrix codes is
not available. Even enabling the human readable text by Laser Marker NAVI smart, it is disabled when this command is
used.
Data contents
[byte]
1 "0"–"7": Object No. 1100 to 1107
1 "0"–"9", "A"–"F"
"20": Data matrix without human
readable text
"21": GS1 data matrix without human
2
readable text
"22": GS1 data matrix with human
readable text
"0": One-byte mode
1
"1": Kanji mode
2
"00", "08"–"88"
(Combination of vertical and horizontal
is limited *1)
2
8
"-999.999"–"+999.999" [mm]
8
7 "-180.00"–"+180.00" [°]
5
"0.001"–"9.999" [mm]
5
42 The data length is fixed.
ME-LP-GS-SR-COMP-3
Remarks
This value does not affect the settings
anymore.
With LP-400/V compatible command
mode, the automatic setting of the
human readable text to Data matrix
codes is not available.
Specify "0" for GS1 data matrix.
• The number of characters that can
be input varies depending on the
symbol size.
• Specifying "00" for the symbol size
(both for horizontal and vertical)
encodes by the minimum size
(square).
It is the center coordinate of the code.
The rotation center is the center of the
code symbol.
95