Panasonic LP-GS Series Serial Communication Command Manual page 53

Type Name
Graphic file (VEC format file)
Graphic object settings
(VEC format file)
Point radiation parameters
Point radiation correction
File settings
External offset settings
External offset values
Step & repeat settings
Step & repeat fine-adjustment
Motion settings *2
Encoder resolution *2
Line speed *2
Workpiece spacing *2
Code Functions
CDF Sets the graphic file (VEC format) used for the graphic
object.
CDC Sets the parameters such as the position and size of
the graphic object (VEC format file).
PRD Sets the position, time and laser power correction
ratio of the point radiation.
PRF Specifies the offset value of the position and laser
power to the all points set in the selected object no.
ALC Adjusts the marking position and layout for each file.
These settings are applied to all marking data in the
selected file.
OFC Sets the I/O input method for "External Offset
Function" to adjust the marking position for the entire
marking data in the file.
OFS Sets offset value of marking position used for "External
Offset Function" with I/O input.
SRC Sets the condition of "Step & repeat" to mark the
same marking contents on multiple locations in one
file.
SRA Sets the fine-adjustment of "Step & repeat" to mark
the same marking contents on multiple locations in
one file.
TRG Sets the basic configuration of the on-the-fly marking,
such as moving direction and etc. The settings are
applied to all marking files.
ENC Sets the encoder resolution value used for the on-the-
fly marking. This setting is applied to all marking files.
LSP Sets the line speed of on-the-fly marking for the
selected marking file.
INT Sets the workpiece spacing of on-the-fly marking at
regular intervals for the selected marking file.
ME-LP-GS-SR-COMP-3
Refer
(P.105)
(P.106)
(P.108)
(P.112)
(P.113)
(P.114)
(P.115)
(P.116)
(P.118)
(P.123)
(P.124)
(P.125)
(P.126)
53