Panasonic DVC PRO Studio AJ-D950P Service Manual page 954

1-2-7.COMPONENT Pr CLAMP LEVEL ADJ.
BOARD F6 SUB
0V ± 50mV
SPEC.
TEST POINT Pr_OUT
ADJ. VR3008
INPUT SDI IN 100% CB 0% SETUP
MODE EE
TAPE
M.EQ O SCI LLO SCO PE
1. Adjust VR3008 so that the Pr clamped pedestal
level is at scope GND level.
    
     
    
1-2-8.COMPONENT Y-Pb TIMING ADJ.
BOARD F6 SUB
0 ± 10ns
SPEC.
TEST POINT Y_OUT, Pb_OUT
ADJ. VR3005
INPUT SDI IN BOWTIE
MODE
TAPE
M.EQ WFM
1. Adjust VR3005 so that the cross point of envelope
is at center.