Table of Contents
Advertisement
3-3-7. Removal of Mechanism Unit
1.
Remove the front loading unit.
2.
Remove the connector P1 and P2 which are
connected to mech interface at VTR bottom.
Remove the A/C Head cable from the intermediate
point, and remove the P5003 and P5002 which are
connected between the cylinder unit and Head Buffer
board. Then remove the 3 screws and remove the
mechanism unit.
3-3-8. Removal of Fan Motor
1.
Remove the Rear Jack by removing 7 screws.
2.
Remove 2 screws and Power 2 connector P14
then remove the fan motor.
3.
Remove 2 screws and mother board connector
P32, then remove fan motor.
Advertisement
Chapters
Table of Contents
