Table of Contents
Advertisement
Controls and their functions
<Connector area>
!6 ANALOG COMPONENT VIDEO OUT connector (option)
!7 ANALOG COMPOSITE VIDEO OUT connectors
!8 DIGITAL AUDIO IN/OUT connector
!9 SERIAL DIGITAL COMPONENT AUDIO/VIDEO IN/OUT connector
@0 Remote control connectors
@1 ENCODER REMOTE connector
@2 RS-232C connector
@3 PARALLEL REMOTE connector
The analog component video signal is output from this connector.
The analog composite video signals are output from these connectors.
The video signal with signals superimposed on it can be output from the VIDEO OUT3
connector.
The superimpose function can be set ON or OFF on the setup menu No. 007 (SUPER).
This I/O connector is for digital audio signals which comply with the AES/EBU standard.
This I/O connector is for digital component audio and video signals which comply with the
SMPTE 259M-C, 272M/EBU Tech.3267-E standard.
The unit can be controlled from an external source by connecting the unit with another unit
or an external controller.
There are two remote control connectors, one for IN/OUT uses and the other for OUT
uses.
IN/OUT: For connection with an external controller.
For connection with deck-to-deck operation.
OUT:
For connection with parallel running operations.
For use in a loop-through configuration.
The external encoder/controller is hooked up to this connector when the video output
signal and other settings are to be adjusted from an external source.
This is used when operating the unit from an external source.
(continued)
– E-19 –
Advertisement
Chapters
Table of Contents
