Table of Contents
Advertisement
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Remove the connector P15 on Mech. Interconnection board.
5. Remove 2 screws (A) and remove the Supply Brake Solenoid
Base Unit.
6. Remove 2 screws (B) and remove the Supply Brake Solenoid from
its unit.
(Installation of Brake Solenoid)
1. Install a new supply brake solenoid as reverse order of its removal.
Note:
Set the supply brake spring at the position shown in the figure.
2. After installation, adjust following procedures.
(Adjustment Procedures)
1. Set the Reel Table at M cassette position.
2. Confirm the gap (A) between Brake pad and Turn table is 0.2 mm
to 0.5 mm.
3. If the gap (A) is out of specification, loosen 2 screws and adjust
brake solenoid unit as arrow direction so that the gap is in the
specification.
4. After the above adjustment move the Reel Table to S cassette or L
cassette position and confirm the gap is in the specification.
Supply Brake Solenoid Removal
61
Advertisement
Chapters
Table of Contents
