Panasonic DVC PRO Studio AJ-D950P Service Manual page 11

5.3.5. Removal of Front Loading Unit
1. Remove the connectors at front loading motor and interconnection
board. Then rotate the emergency eject gear (red)
counterclockwise until the screw which is used to fix the front
loading u can be seen.
2. Remove the 4 screws of the loading unit as shown below.
5.3.6. Removal of Power Supply Unit
1. Remove 5 connectors with the Power Supply unit on the VTR
bottom side.
2. Remove 2 screws with the Power Supply unit on the VTR bottom
side.
11