Table of Contents
Advertisement
4. When Height is Adjusted, loosen the screw H. After the adjustment
tighten screw H.
5. When the each Adjustment is done, each adjustment screw must
be rotated CW. And hit slightly the L part to remove the
mechanical distortion.
6. Adjust or confirm alternately each Adjustment and Envelope
Output waveform Adjustment.
5.6.16. A/C Head Tilt Adjustment
Specification
Adjustment
Mode
Tape
Tool
1. Adjust A/C Head Tilt by screw A so that the Tape is at lower limit at
T3 Post.
2. For this Adjustment, loosen screw G and make tape curling at T3
lower flange then gradually tighten screw G to make the tape flat.
The screw G tightening torque is 1.0 Kg/cm.
(Reference)
1. Screw A CW: Tape up, Screw A CCW: Tape down
No curling and bending at tape edge.
T3 Post Lower Limit
Screw A, G (A/C Head)
PLAY
Work Tape
VFK1148,VFK1178 (Hex Wrench)
28
Advertisement
Chapters
Table of Contents
