Table of Contents
Advertisement
5. Remove the Pinch Solenoid Unit. (Refer to Pinch Solenoid
Replacement.)
6. Remove the screw (B) and remove the Emergency Shaft.
7. Remove 2 screws (C) and remove the Loading Motor Neutral Unit.
8. Remove 2 screws (D) and remove the Loading Motor.
(Installation of Loading Motor)
1. Install a new Loading Motor with 2 screws (D) to the Loading Motor
Neutral Unit.
2. Install the Loading Motor unit with 2 screws (C). For this
installation, be careful that the pin of Mode SW unit should be
matched to groove position of main Cam Gear.
3. Install the emergency shaft with screw (B).
4. Install the Pinch Solenoid Unit. After installation adjust Pinch
Solenoid Position Adjustment. (Refer to Pinch Solenoid Position
Adjustment.)
5. Connect the connector P21.
5.7.14. Mode Switch Unit Replacement
(Removal of Mode Switch Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
Removal of Loading Motor
65
Advertisement
Chapters
Table of Contents
