Table of Contents
Advertisement
Setup menus
USER menu
<OPERATION>
No.
100
101
102
103
104
105
106
107
The underline on the setting item denotes the initial setting.
Item
Setting
Superimposed
Superimposed
No.
display
display
SEARCH
0000
ENA
0001
SHTL MAX
0000
0001
0002
FF. REW
0000
MAX
0001
0002
AUDIO
0000
MUTE
0001
REF
0000
ALARM
0001
AUTO EE
0000
SEL
0001
0002
EE MODE
0000
NORMAL
SEL
0001
PLAY
0000
.
.
DELAY
.
0015
– E-50 –
DIAL
This selects the direct search dial operation.
0: For direct search dial operations.
KEY
1: Operation is not transferred to the search mode unless the
search button is pressed.
×8
This sets the maximum speed for shuttle operations.
×16
0: 8× normal speed
×32
1: 16× normal speed
2: 32× normal speed
×16
This sets the maximum speed for FF and REW operations.
×32
0: 16 (32)× normal speed
×50
1: 32 (60)× normal speed
2: 50 (100)× normal speed
<Note>
Values for the 411 (25M) mode are shown in parentheses ( ).
OFF
This sets the status until the audio signal is output when
operation switches from the stop or search modes to the play
ON
mode.
0: The time until the audio is output is shortened.
1: The audio is output after the status stabilizes.
<Note>
When set to 0 (OFF), the sound in the initially output part is
incomplete. Therefore, this setting is not recommended for
broadcasts.
OFF
This selects whether to warn the operator when the
REF.VIDEO signal has not been connected.
ON
0: Warning is not given.
1: Warning is given by the flashing STOP lamp.
S/F/R
This selects the VTR mode in which the EE status is
established when the TAPE/EE switch is set to EE.
STOP
0: EE status is established in the STOP, FF or REW mode.
BLACK
However, EE status is always established in EJECT mode
regardless of the TAPE/EE switch setting.
1: EE status is established only in the stop mode. However,
EE status is always established in EJECT mode regardless
of the TAPE/EE switch setting.
2: EE status is established only in the stop mode. However,
depending on TAPE/EE switch setting EJECT mode is as
follows:
TAPE/EE switch EE:
TAPE/EE switch TAPE: BLACK status for video
This selects the EE mode output signals.
0: Signals are output with a delay equivalent to the length of
THRU
internal signal processing.
1: Signals are output directly, without internal processing, and
so are output with no delay.
<Note>
When editing mode is selected, SDTI is selected as the video
input signal, or INT SG is selected at either VIDEO or AUDIO,
he internal operations are forcibly set to NORMAL.
0
This set the play delay time in frame increments.
.
.
.
15
Description
EE status
MUTE status for audio
Advertisement
Chapters
Table of Contents
