Table of Contents
Advertisement
5.7.10. Take-up Brake Solenoid Replacement and Adjustment
(Removal of Take-up Brake Solenoid)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Remove the connector P18 on the Mech. Interconnection board.
5. Remove 2 screws (A) and remove the take-up brake solenoid base
unit.
6. Remove 2 screws (B) and remove the Brake Solenoid from the
Take-up Brake Solenoid Base Unit.
(Installation)
1. Install a new Take up Brake Solenoid as reverse order of its
removal.
Note:
Install a take up brake spring as shown in the figure.
Brake Solenoid Position Adjustment
Take up Brake Solenoid Removal
62
Advertisement
Chapters
Table of Contents
