Panasonic DVC PRO Studio AJ-D950P Service Manual page 552

USER menu
<BASIC>
No.
000
001
002
003
004
005
006
007
008
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed Superimposed
No.
display display
P-ROLL 0000
.
.
TIME .
0005
.
.
.
0015
LOCAL 0000
ENA 0001
0002
TAPE 0000
TIMER 0001
REMAIN 0000
SEL 0001
SETUP 0000
NUMBER 0001
METER 0000
SEL 0001
SYNCHRO- 0000
NIZE 0001
SUPER 0000
0001
DISPLAY 0000
SEL 0001
0002
– 47 –
0S This sets the preroll time which can be set from 0 to 15
.
.
. seconds in 1-second increments.
5S <Note>
.
.
. When the unit is set to automatic editing [PREVIEW, AUTO
15S EDIT], the unit will not operate if the preroll time is set to 0
seconds.
DIS
This selects the buttons which can be operated on the front
panel when the REMOTE/LOCAL switch has been set to
ST&EJ
REMOTE.
ENA
0: No buttons can be operated.
1: Only the STOP and EJECT buttons can be operated.
2: All buttons except for the RECORDER and PLAYER
buttons can be operated.
±12h
This selects the 12 or 24 hour display for the CTL counter.
0: 12 hour display
24h
1: 24 hour display
OFF This selects whether the remaining tape time is shown on the
front panel.
ON
0: Not shown.
1: Shown.
<Note>
Even when "Shown" is selected, the remaining tape time is not
shown while the unit is calculating the remaining tape time
after ejecting or inserting the cassette.
This selects whether the SETUP-MENU No. is displayed on-
OFF
screen.
ON
0: The SETUP-MENU No. is not displayed.
1: The SETUP-MENU No. is displayed.
This selects whether the level meters are to display the CUE
CUE
track signal level or the video signal level.
VIDEO
0: The CUE track signal levels are displayed.
1: The video signal levels are displayed.
This selects whether or not to synchronize between two VTRs.
OFF
0: No synchronization. The editing points deviate several
ON
frames, but editing can be started quickly.
1: Synchronization. Allows for error-free editing.
This selects whether the time code and other super display
OFF
which are output to the VIDEO OUT 3/SERIAL OUT 3 con-
ON
nector is to shown.
0: Not shown.
1: Shown.
This selects what information is to be provided by the time code
TIME
and other super displays output to the VIDEO OUT 3/SERIAL
T&STA
OUT 3 connector.
T&S&M
0: Time only.
1: Time and status.
2: Time, status and mode.
<Note>
•
An error message is displayed when an warning or error
occurs.
Description