Panasonic DVC PRO Studio AJ-D950P Service Manual page 64

1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Disconnect the connector P20 on the Mech. Interconnection board.
5. Remove the Pinch Solenoid Unit.
6. Remove 2 Screws (A) and remove the Pinch Solenoid Unit.
7. Remove the cut washer (B) and remove the Pinch Solenoid Lever.
8. Remove the cut washer (C) and remove the Pinch Arm Unit.
(Installation of Pinch Arm Unit)
1. Install a new Pinch Solenoid as reverse order of its removal. After
installation adjust Pinch Solenoid Position Adjustment. (Refer to
Pinch Solenoid Position Adjustment.)
5.7.13. Loading Motor Replacement
(Removal of Loading Motor)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the bottom panel.
4. Disconnect the connector P21 on the Mech. I/F board. Which is
shown in the Supply an Take-up Reel Unit Replacement.
Pinch Arm Unit Replacement
64