NEC UNIVERGE SV8300 Pc Programming Manual page 111

Upgrade Status
4 Abnormal end under
upgrading
5 Under normal opera-
tion after upgrade
(after reset)
STEP6: When the upgrade status is 2 or 4 in the table on step 5, follow processes.
- Upgrade status is 2:
Assign the command data for the appropriate blade except for CM05 Y=0 data.
- Upgrade status is 4:
Mount the blade and perform step 4 and 5 again after time-out period is elapsed (approximate-
ly 3 minutes [depends on the file size] later after the upgrade start)
This is the end of the procedure for firmware program upgrade.
Confirmation Method
Blade Lamp
Indication
RUN lamp is
undefined
(such as OFF, ON)
RUN lamp
(flash)
4-65
Chapter 4 Standard Mode
CME8 Y=2 CME8 Y=0
F00F Firmware version is
not changed
00FF Firmware version is
changed
NWA-033628-001 Rev.1.0
[Upgrade] Category