NEC UNIVERGE SV8300 Pc Programming Manual page 151

Special System Data Entered in the System Data Mode
This section describes the description of special system data (CM05, 10, 20, 90, 97, 9A) entered in the Sys-
tem Data Mode.
CM05
Y
No. MEANING
0 Blade Type
1ST DATA
DATA MEANING
XX ZZ XX : Unit No. (01-50)
ZZ : Slot No. (01-18)
5-7
Chapter 5 System Data Mode
Using System Data Mode
2ND DATA
DATA MEANING
10 Digital Line Circuit Blade for
Multiline Terminal/DSS
Console (CD-8DLCA/
CD-16DLCA)
20 Analog Line Circuit Blade for
Single Line Telephone
(CD-4LCA/CD-8LCA)
21 LLC (OPX) Blade
(CD-4DIOPA/CD-4DIOPB)
30 C.O. Trunk Blade (CD-4COTB)
31 OD Trunk Blade
(CD-4DIOPA/CD-4DIOPB)
32 Direct Inward Dialing Trunk
Blade (CD-4DIOPA/
CD-4DIOPB)
33 LD Trunk Blade
(CD-4DIOPA/CD-4DIOPB)
40 Basic Rate (2B + D) Interface
Trunk Blade (CD-2BRIA)
41 ISDN Primary Rate (23B + D/
30B + D) Interface Blade
(CD-PRTA)
42 CCIS (1.5 Mbps/2 Mbps)
Trunk Blade (CD-CCTA)
43 T1 (1.5 Mbps)/E1 (2 Mbps)
Digital Trunk Interface Blade
(CD-PRTA)
45 QSIG (CD-PRTA)
50 CS/ZT Interface Blade
(CD-4CSIB)
Continued on next page
NWA-033628-001 Rev.1.0