NEC UNIVERGE SV8300 Pc Programming Manual page 224

System Data Save/Load/Verify
Error Message
Failed to save the system data.
Failed to save the system data.
(Could not make the system data
file.)
Failed to save the system data.
(Cannot use the specified system
data area.)
Failed to save the system data.
(The format of the system data is
in valid.)
Failed to back up the system data
to the flash ROM.
Failed to verify the system data.
Failed to verify the system data.
(Could not open the system data
file.)
Failed to verify the system data.
(The format of the system data
file is invalid.)
Failed to verify the system data.
(Cannot use the specified system
data area.)
Failed to verify the system data.
(The format of the system data is
in valid.)
Cause
An error occurred.
The specified folder is write-
protected or enough hard
disk drive space is not avail-
able.
System data saving was
attempted with a system data
area in which no system data
existed specified.
The format of system data to
be read out from the system
is not match with the current
version of the PCPro.
Backing up loaded system
data to flash ROM failed.
An error occurred.
The specified file has been
opened by another applica-
tion.
The system data file has an
invalid format.
System data was verified by
specifying a system data area
in which there was no system
data.
The format of system data to
be read out from the system
is not match with the current
version of the PCPro.
C-12
Appendix C Troubleshooting
Remedial action
Retry.
Specify a write-enabled folder or
a folder having enough hard disk
drive space.
Specify a valid system data area.
Use the PCPro that the format of
system data is match with the
system.
Retry the backup of the system
data to flash ROM.
Retry.
Close the file.
Select a file having the valid con-
figuration.
Select a file having the valid con-
figuration.
Use the PCPro that the format of
system data is match with the
system.
Continued on next page
NWA-033628-001 Rev.1.0