NEC UNIVERGE SV8300 Pc Programming Manual page 79

STEP11: Click the [Apply] button.
The settings are written to the SV8300, and you are directed back to the [Blade Configura-
tion] screen. The slots in which additional blades are mounted are checked.
The following dialog boxes are displayed in accordance with the assigned blade after click-
ing the [Apply] button, then click the [Yes] button.
• LC/LLC/DLC/COT/DID/LD/OD/CSI
[Yes] button
• PRT/DTI/CCT/QSIG
[Yes] button
• BRT/ILC
[Yes] button
Additional blades have now been registered.
4-33
Chapter 4 Standard Mode
[Implement] Category
NWA-033628-001 Rev.1.0