Numbering Plan Setting (Cm20) - NEC UNIVERGE SV8300 Pc Programming Manual

No. Item
(5) IP Address field
(6) [Fill In] button
(7) [Clear] button
STEP3: Click the [OK] button.
You are directed back to the [Quick Setup] screen. Checked mark appears to the right of but-
ton [3].
The IP addresses of maintenance port and VOIP port have now been set.

Numbering Plan Setting (CM20)

Set a station and trunk route numbering plan in these steps:
STEP1: Click the [4] button in the [Quick Setup] screen.
The [4. Setting of Numbering Plan] screen is displayed in the work window.
Enter the IP address (RTP) of the VOIP port.
• 0.0.0.1 to 255.255.255.254 (default: 172.16.1.2)
• Up to 8 IP addresses (RTP) can be entered.
• One IP address (RTP) is required as per 16 channels set of RTP chan-
nels used.
Click to enter up to 7 IP addresses continuously in relation to the IP
address (RTP) of the VOIP port entered on the first line in (5).
• The number of IP addresses that can be entered continuously depends
on the number of RTP channels used selected in (4).
Click to reset the complete set of data to the defaults.
4-12
Chapter 4 Standard Mode
Description
[Implement] Category
NWA-033628-001 Rev.1.0